G8872_1 Installation Manual AUS
9
Replacing a wireless control:
If the wireless control becomes lost or damaged, a new one can be ordered from any Escea
retail agent.
When you have the new remote, the following procedure needs to be followed to “teach” the
remote to only communicate with that fire.
1.
Ensure the fire and remote are set to “Off” (only the time is displayed on the remote).
2.
Turn on the fire using the Aux On/Off (red) button on the front of the fire under the removable
bottom front panel.
3.
Wait 1 ½ minutes until the fan begins to operate, wait a further 15 seconds and then press
and hold the auxiliary On/Off button for no less than 8 seconds (Note: This will also extinguish
the fire).
4.
Immediately after releasing the Aux On/Off button turn on the remote control and wait four to
five minutes. During this time the fire will re-ignite.
NOTE:
During this period the fire will listen for any coded remote signal and re-address itself to
this new code. So make sure the batteries of any other Escea remote that may be nearby are
removed.
5.
The fire is now re-addressed to the new remote control.
Gas Type Conversion
Gas type conversion kits can be ordered from your Escea retailer under the following part
numbers;
NG-850
Natural Gas Conversion Kit - IB850
LPG-850
LPG Conversion Kit - IB850
NG-600
Natural Gas Conversion Kit - IB600
LPG-850
LPG Conversion Kit - IB600
If the heater had not been used before gas type conversion was required then Escea will credit
the cost of the conversion kit when the original parts are returned to Escea.
IB600
IB850