G8872_1 Installation Manual AUS
8
Replacing Electronic Draw
All of the electronic components of the heater have been located on a removable draw.
This draw is located on the left hand outer side of the IB850 and under the front burner of the
IB600. On the back of the draw are two large connectors that unplug as the draw is removed so
only the three wires connecting the electronics to the igniters and flame rod must be removed
manually from the PCB (Printed Circuit Board).
ISOLATE THE POWER TO THE FIRE BEFORE PROCEEDURE.
Step Two:
Take out the two screws at each end of the electronic draw and pull draw directly outwards
Step
Three:
Carefully remove the two wires shown
from the white ignition module.
IB600
= Remove the bottom
fascia trim panel
Step one:
IB850
= Remove outer fascia
by taking out two screws located
behind the bottom fascia trim panel
1.
Flame Rod
2.
Spark Lead
Wire Entry:
IB850
IB600
