1
Instruction Manual
important notiCe
This manual is supplied with Escale 5-channel and EScale 6-channel transmitters. Please note that the 6th
channel and trainer switch mentioned in this manual are not functional on the EScale 5-channel transmitter.
WarninG
CoNNECToR CoNNECTIoN
Insert the receiver, servo, and battery connectors fully and firmly.
If vibration, etc. causes a connector to work loose during flight, the plane may crash.
RECEIVER VIbRATIoN-PRooFING/WATERPRooFING
Vibration-proof the receiver by wrapping it in sponge rubber or some such material. If there is a possibility the
receiver may get wet during use waterproof it by placing it in a plastic bag.
If the receiver is subjected to strong vibration and shock, or gets wet, it may operate erroneously and cause a
crash.
RECEIVER ANTENNA
Do not cut or bundle the receiver antenna. Also, do not bundle the antenna together with the servo lead wires.
Cutting or bundling the receiver antenna will lower the receiver sensitivity and shorten the flight range and cause
a crash.
SERVo THRoW
Operate each servo horn over its full travel and adjust so that the pushrod does not bind or is not too loose.
Unreasonable force applied to the servo horn will adversely affect the servo and drain the battery quickly.
SERVo INSTALLATIoN
Install the servos to the servo mount, etc. through a rubber grommet. Install the servos so that the servo case
does not directly touch the servo mount or other parts of the fuselage, as shown below:
PoWER SWITCH INSTALLATIoN
When installing a receiver power switch to the fuselage, cut a rectangular hole somewhat larger than the full
travel of the switch knob and install the switch so it moves smoothly from ON to OFF.
Also install the switch where it will not come into direct contact with engine oil, dust, etc. Generally, install the
switch to the fuselage at the side opposite the muffler exhaust.
Summary of Contents for 2.4GHz FHSS Radio System
Page 1: ...2 4GHz FHSS Radio System Instruction Manual ...
Page 11: ......
