7
15.
With at least three capable people, raise the backboard
assembly up and have the fourth attach Lower Board Arms to
lower mounting tubes on backboard using two bolts (#20),
four Board Bushings (#22) (shipped already installed), two
spacers (#8), two plastic washers (#5), two washers (#3)
and two hex nuts (#4). See Figure 10.
Note: Do NOT over tighten these bolts. This is a pivot
point. Snug is tight enough.
16.
Attach Upper Board Arms to upper mounting tubes on
backboard using two bolts (#20), four Board Bushings (#22)
(shipped already installed), two spacers (#8), two plastic
washers (#5), two washers (#3) and two hex nuts (#4). See
Figure 10.
Note: Do NOT over tighten these bolts. This is a pivot
point. Snug is tight enough.
17.
Remove protective backboard covering and mount Goal
Assembly (#28) and Rim Pad (#27) to Backboard, as shown in
Figure 11, using four bolts (#29), eight washers (#26), four
lockwashers (#25) and four nuts (#24). Tighten fasteners finger
tight, leave them loose enough to level rim.
18.
Place a level across rim assembly and adjust rim until it is level.
Finish tightening the four nuts.
19.
Attach Rim Cover Plate (#31) using four screws (#32). See
Figure 11.
21.
Adjust unit to lowest position. Use a tape measure to measure
from the top of the rim to the playing surface. Stick Height Decal
(#17) to back of Actuator (#16) with the measured height mark
aligned with bottom of Actuator Sleeve (#15). See Figure 12.
Figure 10
Figure 11
Figure 12
NEVER USE RIM WITH COVERPLATE REMOVED!
ATTACHING BACKBOARD TO BOARD ARMS
REQUIRES AT LEAST FOUR CAPABLE ADULTS.
20.
Check all nuts and bolts and make sure everything is tightened
properly.
Note: Do NOT over tighten these bolts. This is a pivot
point. Snug is tight enough.
All manuals and user guides at all-guides.com
