12
NEVER USE RIM WITH COVERPLATE REMOVED!
28.
Attach rim cover plate (#32) using two screws (#33). See
29.
Check all nuts and bolts and make sure everything is
tightened properly.
DO NOT over tighten
pivot points,
snug is tight enough.
30.
mark the hole locations on the backboard frame. See
Figure
13
and
Detail A
.
Figure 13.
Detalle A
Pad #37 & #38
Screw #42
31.
Drill 9/64" pilot holes into steel backboard frame. See
Detail A. Do not drill through both sides of tube.
32.
Secure backboard pads (#37) and (#38), as shown, using
screws (#42). Note: Tighten screws tight but,
do not over
tighten.
Note: Safety glasses required for Step 31.
Do not over tighten screws.
Note: Cordless drill recommended for screw installation.
37
38
42
42
4
26
40
(Pre-Installed)
29
27
26.
27.
Place a level across rim assembly and adjust rim until
it is level. Finish tightening the four nuts.
Mount goal assembly (#28) and rim pad (#27) to
backboard, as shown in
Figure 13
, using four bolts
(#41), four washers (#26), and four locknuts (#4).
tighten fasteners finger tight, leave them loose
enough to level rim.
Figure 13
41
41
28
32
33
Use the backboard pads (#37) and (#38) as a template and
