22.
Slide actuator handle (#35) onto shaft on the bottom of
Actuator (#16). Line up hole in shaft with hole in actuator
handle and insert Pin (#34) to secure. See
Figure 11
.
23.
To aid in the assembly of the backboard, lower the backboard,
by turning the actuator handle, until the lower arm makes
contact with stop bar behind the top pole.
Figure 11
Figure 10
10
6
22
5
18
4 18
3
15
16
Note: Tighten bolts snug but, do not over tighten. Board
Arms must pivot freely.
20.
Attach upper arms (#6) to top pole (#3), as shown
in
two plastic washers (#5) and one lock nut (#4).
Figure
10
, using a bolt (#22), two flat washers (#18),
If tube plugs (#9) are not already installed insert them into
open ends of the upper board arm (#6). It may be
necessary to use a rubber mallet to tap plugs in.
21.
Note
: Both upper board arms (#6)
must be positioned with “Inner-
Front” stickers facing each other as
shown.
Inside Front
Inside Front
Inside Front
Inside Front
9
35
34
