IMPORTANT! Nylon washers (#5) adequately space
painted parts at all pivot points. Neglecting the use of
these washers will result in rusted parts.
NOTE: All board arms are made of rectangular tubing.
Tightening hardware too tight may damage tubing
and make adjustment of system difficult.
Figure 9
16.
Attach lower arms (#11) to Top Pole (#3), as shown in
Figure 8
, using a hex bolt (#22), two flat washers (#18),
two plastic washers (#5) and lock nut (#4).
Note: make sure lettering is right side up. Do NOT tighten
bolt (#22) at this time.
Figure 8
22
18
5
18
4
3
11
18.
Insert Two Tube Plugs (#9) into open ends of Lower Arms
(#11). It may be necessary to use a rubber mallet to tap them
in. See
Figure 9
.
Note:
Tube plugs may be pre-installed
22
18
5
18
4
11
15,16
9
Detail 3
8
by the factory.
17.
Secure Actuator (#16) to Lower Arms (#11) using one bolt
(#22), two flat washers (#18), two plastic washers (#5) and
one lock nut (#4). See
Figure 9
and
Detail 3
. Tighten both
bolts (#22) snug but,
do not over tighten. Board Arms
must pivot freely.
