User Manual
esatto.house
8
9
Installation Instructions
Typical installation tools required.
You’ll most likely require the following tools/equipment
(not supplied) for the installation of your microwave.
• Electrical drill
• Tape Measure
• Screw-driver
It’s important to carefully read the following installation
instructions before beginning the installation of your
microwave.
IMPORTANT:
Please observe the installation
instructions provided and note that this appliance
should only be installed by a qualified technician.
• Do not attempt to operate this microwave oven with
the door open, as this can result in harmful exposure
to microwave energy. It is important not to break or
tamper with the safety interlocks.
• Do not place any objects between the microwave
oven face and the door, or allow food residue to
accumulate on sealing surfaces.
• If the door or door seals are damaged, the
microwave oven must not be operated until it has
been repaired by an authorised repair agent.
ELECTRICAL CONNECTION
The oven is fitted with a plug and must only be
connected to a properly installed earthed socket. The
socket must only be installed and the connecting cable
must only be replaced by qualified electrician and in
accordance with the appropriate regulations. If the
plug is no longer accessible following installation, an
isolating switch must be present on the installation side
with a contact gap of at least 3mm.
• The fitted cabinet must have ventilation behind
the appliance.
• Do not bend the power cable.
1. CABINETRY
The following diagrams show the correct cabinetry
construction for a built-in installation. Failure to provide
the correct ventilation, as explained below, will void all
warranty claims.
• A minimum 45mm space is required from the
microwave cabinet to the external environment.
• It is also recommended to allow ventilation down to
below the base cabinetry (i.e. under the kickboards)
and to install a vent into the kickboard.
2. PREPARE THE CABINET
Note:
Ventilation is critical for underbench installation
also, either venting through the cabinet rear or down
below the cabinetry (i.e. behind the kickboard).
380+2
45
45
600
560+8
min
550
Read the instructions on the BOTTOM CABINET TEMPLATE and position
the template on to the base panel of your cabinet.
Mark the base panel of your cabinet, according to “A” indicated on
the template.
Remove the template and fix the mounting bracket in place with
2 x Screw A.
