5 OPERATION
0446 680 001
- 24 -
© ESAB AB 2021
5.11
Attaching both the wheel kit and the torch
strain relief accessory
1) If the torch strain relief accessory is to be used with the wheel kit when it is fitted in the vertical
position, the assembly steps below must be completed in the following order:
Attach the torch strain relief to the wire feed unit, using the two Torx 5 screws.
Attach the wheel kit to the wire feeder using the two screw joints near the rear end of the wire
feeder. Ensure that the two distance washers are inserted between the wheel kit and the wire
feeder.
Fasten the wheel kit and the torch strain relief to the wire feeder using the two screw joints located
closer to the front end of the wire feeder.
Summary of Contents for RobustFeed AVS
