ESAB Origo Mig C170 3ph, Instruction Manual

Page: 7 / 24

- 7 -
ba46e
Mig C250 3ph Mig C200 3ph Mig C170 3ph
Spot welding 0.2-2.5s 0.2-2,5s 0.2-2.5s
Welding gun connection EURO EURO EURO
Wire dimension range 0.6-0.8(Fe, SS)
1.0(Al)
0.8(FCW)
0.8-1.0(CuSi) 0.6-1.0(Fe, SS)
1.0(Al)
0.8-1.0(FCW)
0.8-1.0(CuSi) 0.6-1.2(Fe, SS)
1.0-1.2(Al)
0.8-1.2(FCW)
0.8-1.0(CuSi)
Max diameter / weight of
wire bobin 300mm/15kg 300mm/15kg 300mm/15kg
Dimensions lxwxh 860x420x730 860x420x730 860x420x730
Weight 63.5kg 72.5kg 82kg
Operating temperature -10
÷
+40°C -10
÷
+40°C -10
÷
+40°C
Transportation temperature -20
÷
+55°C -20
÷
+55°C -20
÷
+55°C
Enclosure class IP 23 IP 23 IP 23
Application classification
Duty cycle
The duty cycle refers to the time as a percentage of a ten-minute period that you can weld or cut at
a certain load without overloading. The duty cycle is valid for 40
°
C.
Enclosure class
The IP code indicates the enclosure class, i. e. the degree of protection against penetration by solid
objects or water. Equipment marked IP23 is designed for indoor and outdoor use.
Application class
The symbol indicates that the power source is designed for use in areas with increased
electrical hazard.
4 INSTALLATION
The installation must be carried out by a professional.
Note!
Connect the power source to the electricity mains with a network impedance of 0.268 (C250 3ph) ohm
or lower. If the network impedance is higher, there is a risk of flicker in the illuminators.
CAUTION
This product is intended for industrial use. In a domestic environment this product may
cause radio interference. It is the user's responsibility to take adequate precautions.
4.1 Location
Position the welding power source in such way that its cooling air inlets and outlets
are not obstructed.
GB