-- 8 --
OF30e
j.
Connect current cables. Set voltage in the welding rectifier. Switch the
rectifier on. The machine is ready for welding.
The wire feeder is factory -- equipped with insulating feet that allow to put the feeder
on top of power source or directly on the ground.
Feeder can optionally be equipped with accessory wheel set (see page 18).
5
OPERATION
General safety regulations for the handling of the equipment can be found on
page 4. Read through before you start using the equipment!
WARNING!
Assure that the side panels are closed during operation.
WARNING!
Rotating parts can cause injury, take great care.
To prevent the reel sliding off the hub: Lock the reel in place by turning
the red knob as shown on the warning label attached next to the hub.
WARNING!
When moving the equipment use intended handle.
NOTE!
Never pull on the gun.
5.1
Connection and control devices
1
Power ON indicator
7
Cooling liquid connectors with pump switch
(Feed 30w)
2
Wire feeder speed knob
8
Torch connector
3
Mode selector (see table below)
9
Control cable terminal
4
Burn--back time knob
10
Gas inlet
5
Spot welding time knob
11
Current terminal (from power source)
6
Creep speed knob
12
Cooling liquid connectors (Feed 30w)
Symbols explanation:
wire feeding / inching
gas purge
2--stroke
burn--back
4--stroke
creep speed
spot welding / spot
welding time
GB
