ESAB KHM 190 HS, Instruction Manual

Page: 14 / 98

2
0
/6
/0
0
ESABM
2
5
G
BH
86($1'0$,17(1$1&(
35(3$5,1*7+(81,7*$62/,1((1*,1(6
0
25
ü
:$51,1*
Gasoline is highly flammable. Refuel in well venti-
lated area with the engine stopped. Do not fuel in
the presence of open flames. Be careful not to spill
fuel. Spilled fuel or vapor may ignite. If any fuel is
spilled be sure the area is dry before starting the en-
gine.
/8%5,&$17
The engine is shipped without oil. Use a 4-stroke, high de-
tergent, premium quality motor oil certified to meet or ex-
ceed U.S. automobile manufacturer’s requirements for
service classification SG, SF. Motor oils classified SG, SF
wíll show this designation on the container. Refer to the
engine manual for recommended viscosities.
SAE lOW-30 is recommended for general, all temperature
use. lf single viscosity oil is used, select the appropriate
víscosity for the average temperature in your area.
To check the oil level:
1. Remove the oil filler cap and wipe the dipstíck clean.
2. Insert the dipstick into the oíl filler neck, but do not screw
it in.
3. If the level is low, fill to the top of the oil filler neck wíth
the recommended oil.
(1*,1(:,7+2,/$/(57'(9,&(
The Oil Alert System is designed to prevent engine damage
caused by an insufficient amount of oil in the crankcase.
Before the oil level in the crankcase can fall below a safe
limit, the Oil Alart System will automatically stop the engine
(the engine switch wili remain in the ON position).
If the engine stops and will not restart, check the engine oil
level.
$,5),/7(5
Check that the dry air filter is correctly installed and that
there is no air leakage around the filter which could let unfil-
tered air into the engine.
)8(/
Fill the tank with automotive gasoline (unleaded or lowlead
is preferred to minimize combustion chamber deposits).
*5281'&211(&7,21
A good ground is obligatory for all models with GFI (ground
fault interrupter). This protective device will not protect the
operator unless there is a good ground.
+
Use a good quality ground cable and connect it to the
grounding point of the machine. Follow all local rules
and/or regulations.
Once the above operations have been completed, the ma-
chine can be used.
*%