ESAB ES 95i, Operating Manual

Page: 18 / 40

ESAB ES 95i
INSTALLATION 3-6 Manual 0-5458
SMAW (Stick) Mode Sequence of Operation
!
CAUTION
Before any welding is to begin, be sure to wear all appropriate and recommended safety equipment.
1. Switch the ON/OFF Switch (located on the rear panel) to OFF.
2. Connect the ground clamp cable to the negative output terminal, and the electrode holder cable to the positive output terminal.
NOTE!
This set up is known as DC Electrode Positive or reverse polarity. Please consult with the stick electrode
manufacturer for specific polarity recommendations.
3. Connect the ground clamp to your workpiece.
4. Plug the power cable into the appropriate outlet, and turn the switch to the “ON” position. The power L.E.D light should
illuminate.
5. Set the “Process Selection Switch” to SMAW (Stick)
6. Set the weld current control knob to the desired amperage.
7. Install a stick electrode in the electrode holder.
8. You are now ready to begin SMAW (Stick) Welding
NOTE!
Gently strike the electrode on the work piece to generate a welding arc, and slowly move along the work
piece while holding a consistent arc length above base metal.
Figure 3-2: Setup for SMAW (Stick) Welding
3.06 SMAW (Stick) Setup
200A
Set Welding Current
as specified by the
Electrode Manufacturer.
Set Process Selection
Switch to SMAW (Stick)
Positive Output
Terminal
(Dinse™ 25)
Negative Output
Terminal
(Dinse™ 25)
Art #: A-08602_AC