5 OPERATION
0440 001 001
- 13 -
© ESAB AB 2020
5.1
Connection and control devices
1.
Mains supply switch
4.
Return cable
2.
Display
5.
Mains cable
3.
Welding torch
6.
Gas connection
5.2
Operation
The power source is not powered instantly when the mains switch (1) is turned on. After
approximately 2 seconds the display (2) indicates that the power source is ready.
If the welding torch trigger is pressed while the power source is being turned on, the
operation is disabled, until the trigger is released.
The return cable (4) must be reliably connected to the workpiece or to the welding table.
The side panel covering the wire feeder must be closed prior to the welding.
The power source is instantly switched off by means of the mains switch (1).
