7
Note: The extruder will not work until the temperature is higher than 170
℃ .
(Temperature protection feature)
Preheat your hotend at first. Click your LCD button→Prepare→Preheat PLA End.
Insert filament into the Teflon tube. When the filament goes though extruder block,
with one hand press the handle, make sure the filament can go though the slot of
the gear, then guide filament in by hand till filament starts to string from the hotend.
After pushing the filament into the bottom of hotend,
click LCD button→Prepare→Auto home.
When homing the axis is finished. You can click LCD button→Prepare→Change
filament
Choose “Preheat PLA” the hotend will heating then you need to click the LCD but-
ton to continue.
You can click” Purge more” a few times till the filament comes out of the nozzle.
-Load the filament
