7
USER’S MOUNTING INSTRUCTIONS
After the initial set-up assembly is completed, use the following procedure to mount the attachment to the loader.
Coupler wedges or pins must extend through holes in attachment. Levers must be fully
down and locked. Failure to secure wedges or pins can allow the attachment to come off and cause injury
or death.
IMPORTANT:
This attachment is not designed to be used on loaders with a Rated Operating Capacity (ROC)
of more than 1000 pounds.
Instructions for mounting to a ride-on
mini skid steer:
1. Use the step, safety treads, and grab handles to
get on and off the loader and attachment.
2.
Sitting in the operator’s seat, lower the seat bar,
fasten the seat belt, make sure all controls are in
neutral, and start the engine.
3. Drive the loader to the rear of the attachment.
Put the loader quick attach coupler into the
attachment mounting bracket.
4. Tilt the loader coupler back a small amount until
it is fully engaged with the attachment mounting
bracket.
5. Stop the engine and engage the park brake.
6. Exit the loader and secure the coupler locking
mechanism that locks the attachment to the
loader.
Instructions for mounting to a
walk-behind mini skid steer:
1.
Standing at the operator’s station, make sure all
controls are in neutral, and start the engine.
2. Drive the loader to the rear of the attachment.
Put the loader quick attach coupler into the
attachment mounting bracket.
3. Tilt the loader coupler back a small amount until
it is fully engaged with the attachment mounting
bracket.
4. Stop the engine and engage the park brake.
5. Walk to the front of the loader and secure the
coupler locking mechanism that locks the
attachment to the loader.
