9
Category I
Category II
6.
Install the lower 3-point pins as shown. Category
I arms will mount between the tank brackets, so
the pins should be mounted to the inside as
shown.
7.
Category II arms will mount outside the tank
brackets, so the pins should be mounted to the
outside as shown.
8.
The top pin has two positions. The pin should be
mounted in the top hole when connecting the
tractor top link directly to the tank. The pin should
be mounted in the bottom hole when connecting
to the tank using a quick-hitch system.
NOTE:
Additional bushings may be needed on
the upper and lower pins if using a quick-hitch
system. These are not supplied with the power
unit.
9.
Set-up assembly of the pump is now complete.
See “Mounting Instructions” on pages 12-13 for
instructions on mounting the tank to the tractor for
operation. Be sure to check that all fittings are
tight after mounting the PTO pump for the first
time.
SET-UP ASSEMBLY
