Erreka VULCAN D VUA12, Installer Manual

Page: 59 / 104

Instalacion_240.fm -
21
/2/13
VULCAN D Hydraulic operator
55
INSTALLATION
Connect the operator to the control board
Position the cover and tighten the gland

Before making any electrical connections,
check the control board instructions manual.

We recommend using the VIVO-M101(M) or VIVO-
M201(M) control boards.

The connection of an operator in the VIVO-
M201(M) control board is shown as an example. If a
single operator is used, use cable connectors G1, G2
and G3.
1
Connect the operator to the control board using
cable connectors G1, G2 and G3.
2
Connect the capacitor (C) to cable connectors G1
and G2.
3
Connect the control board to the electricity supply.
4
Activate the power supply switch.

Before carrying out any gate movement,
ensure there is no person or object in the radius
of action of the gate and the drive mechanisms.
5
Use the PUL1-PUL2 control board mini-pushbuttons
(CLOSE-OPEN) to check the motor connections are
correct (turning direction).

If the turning direction is not correct,
interchange cables 2 and 3.

Ensure the earth cable is properly connected.
1
Position the cover (1) in its housing (2) and secure
with the screws (3).
2
Tighten the gland (4) to ensure the electrical cable
input (5) is seal tight.
P240W
ST1 FT1
P1 P2 P3
ST2 FT2
P4 P5 P6
STOP
P7 P8
P11 P12
LOCK FCA1 FCC1
P15 P14 P16 P22 P23
Courtesy
Light
Lamp.
G7 G8 G9 G10
24Vac
G4 G5 G6 G1 G2 G3
FCA2 COM FCC2 SCA
N L
POWER
MOTOR2 (G2-G1-COM) MOTOR1 (G2-G1-COM)
N L
VIVO- M201:
230Vac/ 50Hz
VIVO- M201M:
125Vac/ 60Hz
A1
VIVO- M201(M)
PUL1
PUL2
1 Motor connection (common)
2 Motor connection (Turn 1)
3 Motor connection (Turn 2)
4 Earth

Since this is a stationary unit for
permanent connection, an external cut-
off must be fitted.
P240U