Installation Guide
12
3.2.3
way to set the analog and IP Dome Cameras’ ID number is specified as
follows.
han one Dome
ge your speed
Dome Camera’s ID by turning the arrow to the desired number respectively.
Fo
et as below.
NOTE:
No two cameras should be given the same ID, or
communication conflict may occur.
ID Setting
The
Analog
Dome
Camera
Please change the analog Dome Camera’s ID if there is more t
Camera on the same installation site. Use the switch to chan
r instance, if the camera’s ID is 123, the ID switch should be s
Centesimal Digit Decimal Digit Single Digit
own in above
Define the protocol you are going to use basing on the devices of your
surveillance system. Generally, use one protocol even the devices are
provided from different manufacturers. Use the switch to set your camera
control protocol and the baud rate. Refer to the table below and turn the
arrow to choose a protocol for your Dome Camera.
NOTE:
The number “0” should locate upwards as sh
diagram for correct switch definition.
Control Protocol Setting
Camera
