Reset the peak value memory single:
• at digital input 3, connect screw terminal 3 to screw terminal 6
• at leaving the programming
7.2.3. Peak value memory double
If the input signal is below the signal level, which is programmed in parameter 2-02,
the panel meter works in normaly mode. If the input signal exceeded the programmed
signal level and the delay time is run down the highest input signal will be stored.
The memory time is endless.
If a higher signal comes in, the higher signal will be stored and displayed. If the input
signal fall under the signal level and exceed the signal level at a new a new start for
the peak value takes place.
Reset the peak value memory double:
• at digital input 3, connect screw terminal 3 to screw terminal 6
• at leaving the programming
•
7.3.
Display test
When activating the displaytest all segments of the display are light on. The display
shows “8.8.8.8.”
Activating the display test:
• By activating the digital input 1, connecting screw terminal 1 and 6
7. Software functions
21
ERMA-Electronic GmbH
Summary of Contents for TM 2500
Page 26: ...10 Notices 10 Notices 25 ERMA Electronic GmbH ...
Page 27: ......
