Erie 2400VS Series, Technical Manual

Page: 15 / 33

2400VS SERIES
Erie Water Treatment Controls – Belgium
Page 11
Programming instructions - Parameter Set level
In the Parameter Set level the basic configuration parameters of the unit can be programmed, depending on the
specific configuration of the unit.
Before entering the programming mode, make sure that the control valve is in the service mode.
1.
Press the scroll button and hold it for 5 sec until the display shows:
2. Within 10 sec, press the up
button; the display will show:
 Press the up button or down button to set the units of hardness .
3.
Press the scroll button again; the display will show:
 Press the up button or down button to set the exchange capacity per litre of resin .
4.
Press the scroll button again; the display will show:

Press the up button or down button to set the volume of resin .
5.
Press the scroll button again; the display will show:
 Press the up button or down button to set the number of days between regenerations .
6.
Press the scroll button again; the display will show:
 Press the up button or down button to set the length of the regeneration cycle .
Default setting Setting range
Cycle 1 Backwash 5 min 0-20 min
Cycle 2 Brine draw/slow rinse 60 min 0-180 min
Cycle 3 Fast rinse/refill 5 min 0-65 min
7.
Press the scroll button again; the display will show:
 Press the up button or down button to set the model of flow meter used :
- SNAP SENSOR : model with snap-on flow meter sensor.
-
SCREW SENSOR : model with sensor fixed by means of screw.
System Check
Cycle 1: 5 min
HardUnit:°f
ExCap:5.2°f M3/L
Resin: 20 liters
Override: 4 days
MTR:SNAP SENSOR
5: XX min