Erie 2400TS Series, Technical Manual, Page: 23 / 31

2400TS SERIES
Erie Water Treatment Controls – Belgium
Page 21
Excessive water in brine tank
Cause Solution
1. Control valve fails to draw brine 1. Refer to problem “Control valve fails to draw brine”
2. Improper fast rinse/brine refill time
setting 2. Verify that fast rinse/brine refill time corresponds to the proper
salt level and amount of resin
3. Improper or missing brine refill flow
control 3. Verify that flow control is installed and properly sized
4. Leak between rotor and seal disk 4. Verify or replace rotor and seal disk
Control valve fails to refill brine tank
Cause Solution
1. Improper fast rinse/brine refill time
setting 1. Verify that fast rinse/brine refill time corresponds to salt level
and amount of resin
2. Improper refill flow control 2. Verify that flow control is properly sized
3. Plugged refill flow control 3. Verify that flow control is free of debris
Unit uses too much salt
Cause Solution
1. Excessive water in brine tank 1. Refer to problem “Excessive water in brine tank”
2. Unit regenerates too frequently 2. Verify program
Salt water to service
Cause Solution
1. Excessive water in brine tank 1. Refer to problem “Excessive water in brine tank”
2. Injector undersized 2. Verify injector selection
3. Improper brine/slow rinse time setting 3. Verify that brine/slow rinse time corresponds to the proper salt
level and amount of resin
4. Improper fast rinse/brine refill time
setting 4. Verify that fast rinse time corresponds to the proper salt level
and amount of resin
Loss of resin through drain line
Cause Solution
1. Improper or missing backwash flow
control 1. Verify that flow control is installed and correctly sized
2. Lower and/or upper distributor
damaged 2. Replace distributor(s)
3. Leak between riser tube and upper
distributor 3. Verify that riser tube is seated correctly and is not cracked