R290 User’s Guide
18
For the call duration and cost, the display will show:
For the total call duration and cost, the display will show:
The bottom line shows the call cost, and the duration is shown above it.
To Change the Ring Volume
Press the up or down key on the side of the phone while the phone is
ringing before accepting an incoming call. The volume level will be
indicated by the amount of squares shown on the display.
You can also change the ring volume from the Ring Tone Menu; refer to
“Personalizing Your Phone” on page 30.
To Change Key Tone Volume
To increase or decrease the key tone volume from stand-by, press the up
or down key on the side of the phone when no calls are in progress. The
volume level will be indicated by the number of squares shown on the
display.
To Redial the Last Dialled Number
With the phone in the stand-by state and no number displayed, press
SOFT RIGHT
to display and dial the last number called. Press
NO
to
finish the call.
Using Auto-Redial
If auto-redial is enabled from the Call Set-Up, Busy Numbers Menu and
your attempt to make a call was unsuccessful because the receiver was
busy or unobtainable, the message ‘Auto Redial’ will be displayed and
the number will be automatically re-dialled unless the party is not
available for a long term reason. Re-dialling will continue until the
number has been connected or the maximum number of 9 retries has been
exceeded. When the auto-redial attempt is activated, the auto-redial
warning tone will be played, the backlight switched on, and the message
‘Connecting’ will be displayed with the dialled number. See “Busy
Numbers” on page 30 for details on enabling and disabling Auto-Redial.
You can enter menu mode, store and recall numbers etc. as normal,
between auto-redial attempts, but re-dialling will not continue until you
Summary of Contents for SATELLITE R290
Page 11: ...R290 User s Guide 3 The Phone ...
