34
Figure 24. Antenna Cutting Chart, 450-512 MHz
3
GENERAL INFORMATION
The procedures in this manual cover the motorcycle installation of an
S-825 Series Control Unit, a RANGR two-way radio, and associated items.
The instructions in this manual are typical installation instructions, and are
not intended to cover all makes and models of motorcycles available.
To simplify installation and minimize difficulties, it is suggested that the
installer read the entire manual pertaining to this application before
starting the installation.
NOTICE
Ericsson Inc. does not assume liability for possible
degradation of the radio performance or motorcycle
performance due to installers mounting procedure. Radio
installation shall be in the horizontal plane.
TOOLS REQUIRED
A few specific tools are required to complete the motorcycle installation.
These are:
•
Soldering iron,
•
Wire crimpers (ST2602),
•
(9/64") drill for backup plate mounting screws,
•
TORX
driver,
•
Adjustable wrench or 5/16" and 7/16" box wrench,
•
Hex drivers: #10, #25, and #30,
•
1/2-20 bolts,
•
Flat blade screwdriver, and
•
Hex wrench set for motorcycle fairing.
TORX
is a registered Trademark of CAMCAR Division of Textron, Inc.
Summary of Contents for S-825 Series
