Charger Control Board
To remove the Charger Control Board, perform the
following steps:
1.
Disassemble the charger (see Case disassembly proce-
dure).
2.
Disconnect the Power Supply Cable (item 15) from con-
nector CNIOI.
3.
Disconnect the Output PCB cable from connector CN102.
4.
Remove the three screws with washers (item 35) securing
the board to the power supply and remove the Charger
Control Board from the bottom assembly.
Reinstall:
5.
Orient the Charger Control Board on the Power Supply as
shown in the Illustrated Parts Break down.
6.
Install three screws with washers to secure the board
(removed in step 4).
7.
Reconnect the Output PCB cable to CN102.
8.
Reconnect the Power Supply Cable to CN103.
9.
Reassemble charger and install battery sleeve.
Power Supply
To remove the Power Supply, perform the following
steps:
1.
Disassemble the charger (see Case disassembly proce-
dure).
2.
Remove the Charger Control Board (see Charger Control
Board removal).
3.
Remove the two screws (item 30) holding the Power
Supply to the bottom assembly (item 1).
4.
Remove the Power Supply by gently pressing out on the
tab surrounding the power connector and lift the Power-
Supply out of the bottom assembly. Reinstall:
5.
Orient the Power Supply power connector with the con-
nector tab on the bottom assembly.
6.
Align the Power Supply screw holes with bottom assem-
bly screw holes. Press down firmly on the Power Supply
until it snaps into place in the bottom assembly.
7.
Reseat the connector tab around the power connector.
8.
Reinstall the two screws to secure the Power Supply to
the bottom assembly (removed in step 3).
9.
Reinstall the Charger Control Board.
l0. Reassemble the charger and install the battery sleeve.
Figure 2 - Sleeve Installation
AE/LZB 119 1643
10