Unlicensed LPWA Gateway 5780
1/1553-KRC 161 673 UEN Rev PB9 2017-03-24
Ericsson AB 2017
35 (45)
Commercial in confidence
7
Management
7.1
SNMP Management Interface
The Gateway 5780 has support for Simple Network Management Protocol
(SNMP) versions SNMPv2 and SNMPv3. This SNMP support enables
integration with any SNMP-based network management system (NMS). The
SNMP interface of the Gateway 5780 uses standard MIBs and enterprise
MIBs. The Gateway 5780 supports fetching the following types of information:
General managed objects (MOs): Basic, Environmental and Inventory
Alarm and event data: Historical alarms and events
Performance data: Performance counter values
NW controller address setting
– what NW server to connect to
Set FW update credentials
– FW version to be fetched update of Gateway
5780
Notifications from the Gateway 5780 are sent using SNMP v2 and SNMP v3
traps.
SNMP can be accessed both locally and remotely:
SNMP via LMT (Local Management Terminal)
SNMP via ETH backhaul
7.2
Gateway 5780 Configuration management
The Gateway 5780 must be configured with a set of configuration parameters
in order to function in the correct way
7.2.1
Gateway 5780 General Configuration settings
The Gateway 5780 is pre-configured at factory with a set of default settings
e.g. radio parameters settings, O&M behavior etc. In this state the Gateway
5780 is non-operational.
Parameters need to be set depending on the actual deployment scenario.
Examples in a new Gateway 5780 network installation, re-configuration due to
added and changed capability, repair of HW etc.
Only qualified installers are to be used for installation of the Gateway 5780.
They are given the required technical information as well as special access to
be able to configure the Operation and Maintenance interface. Access to this
is only possible by using a private encryption key.
