6
7
installation guide
To install the legs, thread the washer over the bolt of the leg with
the recessed side facing the leg, and tighten by hand.
Do not
over tighten.
STEP 1
STEP 2
installation guide
Always use two people when setting up the base.
Place the bed base box in a desired location with the bottom of
the box facing up.
Remove the binding straps and packing materials, making sure
not to puncture the box with any sharp objects.
Remove the bed base from the box keeping the bottom of the base
facing upwards.
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
STEP 10
STEP 11
Uncoil input cord (connected to control box’s
power port) and plug into Power Supply.
To sync two bases with the SmartSync
™
cord - see page 16-17.
To install headboard brackets: See detailed installation
instructions on page 13.
Uncoil the Power Down Box from the frame
and install (2) 9 Volt batteries- not included.
Place box on the ground. Ensure that it is
easily accessible when the base is turned to
its upright position.
Uncoil the Power Cord and connect to the
Power Supply. Place Power Supply on the
ground and extend from the base. Ensure that
the Power Supply and all attached cords are
directed toward the desired surge protector.
Uncoil and extend the Audio Power Cord
toward the desired surge protector. Connect
the other end to the audio input cord, which is
connected to the master speaker.
Carefully flip the base over on to its legs.
Important:
Two people are
required to move the bed base. Do not drag across the floor. Do not
rest frame on its side, excessive pressure may damage the legs.
Plug the base and audio power cord into a power source.
A surge
protector is strongly recommended.
Connect the mattress to the ZipFit™ System*.
Ensure batteries are correctly installed in the back of the remote.
Quickly test functions to verify proper setup before placing mattress on
base. Press FLAT to return the base to a flat position.
Basic setup is now complete! See page 8-9 for remote control
operating instructions.
*If the mattress is not equipped with
the ZipFit™ System:
Slide the left side of the mattress
retainer bar into the bracket. Pull the
retainer bar to the opposite bracket
and secure the right side.
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
