ergoline VARIOBIKE 500, Operation Manual

Page: 36 / 42

variobike 500 Operation Manual
E - 10
Version: 03/02
Art-No: 475.403
Operation Manual
variobike 500
2.2 Scope of Delivery
The standard scope of delivery consists of :
Order No. Description
100.502 ergometer variobike 500
413.093 mains power cable
475.403 Operation Manual (German/English)
optional:
300.937 adjustable cranks, complete with left + right pedal
300.546 saddle bar with fixation for standard saddle
200.177 connecting cable, variobike 500 / 550 to PC (length 5m)
2.3 Setting up and Connecting the variobike 500
On request, our service personnel will install the variobike for you.
• Loosen screws and clamp lever for clamp fixture, and remove upper clamp jaw;
Insert handlebar, secure, and screw tight with screws and tighten lightly with clamp lever.
Adjust appropriate handlebar position and then tighten position with clamp lever.
• Connect cable at the top of the steering column with the control panel;
Position control panel on support, and fix with screws.
• Connect the unit’s power plug via the supplied mains cable to power outlet with same voltage as
indicated at the indication label.
• If applicable, connect the ECG device to the RS232 interface.
2.4 Transport and Relocation
Once set up, you can easily move the variobike 500 to another location. Switch off the ergometer and
remove from the power supply !
Standing in front of the ergometer, grab the handlebars and tilt the variobike 500 towards you. When the
variobike is balanced on its front rollers, you can push it to the new desired location.
Caution when lowering ! Hard impact can damage the measurement electronics of the system!
Putting into Operation