EG_GenTrack23e_997_UG_005_UK
Page 29 / 39
Descriptions and non-contractual illustrations in this document are given as an indication only.
ERCO&GENER reserves the right to make any modifications.
6 Charger supply
6.1 General presentation
The base must be supplied by a regulated filtered stabilized DC external tension (+VDC) b5Vdc and
+15VDC via the micro Fit connector.
The base integrates the charge management system of the battery.
When there is no external supply connected to the 4-pin Micro-Fit connector, the USB supply can be used for
a slow charge of the unit (the time of charge will depend on the voltage available on the USB output)
- Remove the protecting cap of the connector situated under the unit.
- Place the cap on its site on the charger.
- Place the GenTrack 23e on the charger.
- Check the LEDs status (see table hereunder).
- Once the charge is done, reinstall the protecting cap of the connector situated under the unit.
Table: LEDs status of the charger
LED
Status
Interpretation
Off Charger
off
External supply
On (always fix)
Charger on (external supply or USB)
Flashing
Battery not detected.
On (fix)
Battery detected and in charge.
Charge of the GenTrack
23e battery
Off
Battery detected and charge finished.
Led for presence of
external supply
Led of battery charge
Supply micro-Fit
connector
USB connector
Place for the protecting cap
