Erbauer ERI616HTL, Original Instructions Manual

Page: 18 / 28

OPERATION INSTRUCTIONS
NO TE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The power tool is intended for sawing and
separating wooden materials, plastic, plaster,
non-ferrous metals and fasteners (e.g. nails and
clamps) as well as for working on soft wall tiles and
for dry grinding of small surfaces. It is especially
suitable for working close to edges and for flush
cutting.
BEFORE PUTTING INTO OPERATION
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not use
another battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool down
before recharging.
When the battery pack is charged for the first time
and after prolonged storage, the battery pack will
accept a 100% charge after several charge and
discharge cycles.
CHARGING THE BATTERY
A) TO REMOVE THE BATTERY PACK
(See Fig. 1-1)
Depress the Battery Pack Release Button (2) firmly
first and then slide the Battery Pack out from your
tool.
B) TO INSTALL THE BATTERY PACK
(See Fig. 1-2)
Slide the fully charged Battery Pack onto the tool
with sufficient force until it clicks into position.
Fig. 1-1
Fig. 1-3
Fig. 1-2
Fig. 2-1
Fig. 2-2
Fig. 2-3
Fig. 3
Fig. 4
Fig. 5