18V CIRCULAR SAW ERI490CSW
5. DUST/CHIP ExTRACTION (See Fig.7)
Fasten the vacuum adapter (15) onto the dust
extraction outlet (28) until it latches. Directly connect
a suitable vacuum hose to the adapter.
Note:
There is an arrow on the surface of the adapter
which show the tighten direction.
The vacuum adapter must be mounted
anytime.
Clean the vacuum adapter regularly to ensure
optimum dust extraction. The vacuum cleaner must
be suitable for the material to be worked.
STARTING OPERATION
1. SWITHCING ON AND OFF
For starting operation the machine, actuate the lock-
off button (1) first, and then press and hold the On/off
switch (2) afterwards.
To switch off the machine, release the On/off switch (2).
For safety reasons the On/Off switch of the
machine cannot be locked; it must remain
pressed during the entire operation.
2. ELECTRICAL BRAKE
An integrated electrical brake immediately reduces
the speed of the saw together with the saw blade
after switching off the machine.
WoRKING hINTS foR yoUR CoRDLESS
CIRCULAR SAW
Always use a blade suited to the material and material
thickness to be cut. The quality of cut will improve as
the number of blade teeth increase. Always ensure
the work-piece is firmly held or clamped to prevent
movement. Support large panels close to the cut line.
Any movement of the material may affect the quality
of the cut. The blade cuts on the upward stroke and
may chip the uppermost surface or edges of your
work piece when cutting, ensure your uppermost
surface is a non visible surface when your work is
finished.
1. PARALLEL GUIDE (See Fig.8)
Used for making cuts parallel to a work piece edge
at a chosen distance. Slide the parallel guide arm
through both fixtures to achieve the required cutting
distance and tighten screw to lock into position
(7). It can be used from both sides of the base plate
Fig 8
18
19
20
21
22
23
24
25
8
9
0°
45°
28
15
6
7
23
26
5
10
27
Fig 7
18
19
20
21
22
23
24
25
8
9
0°
45°
28
15
6
7
23
26
5
10
27
