18V CIRCULAR SAW ERI490CSW
Red Flashing
Green Off
Defective battery, after
pre-charge 30 minutes
with trickle current, the
total battery voltage is
still less than 10.0V
Red ON
Green Off
Charging
Green ON
Red Off
Power On and Fully
Charged
Green Flashing
Red Off
The temperature of
battery pack is less
than0°or more than
45°C
4. REMOVE OR INSTALL BATTERY PACK (See
Fig.2)
Press the battery pack latch and remove the battery
pack from the drill. After recharge slide the battery
pack into drill’s battery port. A simple push and slight
pressure will be sufficient.
5. CHANGING THE SAW BLADE
Before any work on the machine itself, remove
the battery.
Wear protective gloves when mounting the
saw blade.
Danger of injury when touching the saw
blade.
Only use saw blades that correspond with
the characteristic data given in the operating
instructions.
Do not under any circumstances use grinding
discs as the cutting tool.
For changing the cutting tool, it is best to place the
machine on the face side of the motor housing.
REMOVING
Press the spindle lock button (4) and keep it
depressed.
The spindle lock button (4) may be actuated only
when the saw blade is at a standstill.
Loosen the blade bolt (22) in clockwise direction with
the hex key (24). Remove the outer flange (21). Tilt back
the lower blade guard (13) and hold it firmly with the
lower guard lever (12). Remove the saw blade (20).
MOUNTING
Clean the saw blade and all the clamping parts to be
assembled. Tilt back the lower blade guard (13) and
hold it firmly with the lower guard lever (12). Place the
saw blade (20) onto the inner flange (19). Assemble
Fig 2
18
19
20
21
22
