Erbauer ERB8DLC, Owner'S Manual

Page: 10 / 16

using the tool.
Warning:
Never attempt to grind
Magnesium.
Only use the front face of the grinding wheel but
not the sides. Please note that the work piece can
get very warm. It may be necessary to cool a work
piece by dipping it in a coolant or in water. Do not
apply coolant or water to the grinding wheel.
Turn the wheel by hand to make sure it does not
touch the guard, eye shields, spark deflectors or
work rests and runs freely.
- Stand to one side, turn the switch on and allow
the motor to reach full speed.
Support the work piece on the work rest and
gradually feed the work piece onto the wheel.
Note:
Traverse the work piece across the full
width of the wheel to prolong its flat surface.
If the grinding operation causes the motor speed
to noticeably decrease, pull back the work piece,
allow the motor to regain full speed and restart
the grinding operation, but apply less force.
1. Using the on/off switch
To turn the grinder on, press the On/Off switch to
the position marked “I”.
To turn the grinder off, press the On/Off switch to
the position marked “O”.
2. Using the work light (See Fig 7)
The work light can be used to illuminate the work
area and provide greater visibility. It is controlled
by the On/Off switch.
Remove the light protector to replace a new
bulb.
3. Changing a grinding wheel (See Fig 8, 9,
10)
Important:
Remove the plug from the socket
before changing a wheel.
1) Remove the work rests and the spark deflectors
of both sides.
2) Loosen the three retaining screws and remove
the outer guard. Remove another side of the outer
guard with same operation.
3) Using two spanners (not supplied) to loosen
the nut as shown in Fig 9 with one side rotating
anti-clockwise while another side fixed. Loosen
Fig 8
Fig 7
Fig 9
Fig 10