Erbauer ERB8DLC, Owner'S Manual

Page: 11 / 16

200MM BENCH GRINDER
both of nuts with same operation.
4) Remove the nut, the outer flange and the
wheel.
5) Fix the replaced wheel on the shaft ensuring
that there is a blotter on each side of the wheel.
6) Replace the outer flange and tighten the nut.
7) Replace the outer guard and install the 3
retaining screws.
8) Replace the spark deflectors and the work rests
both sides.
9) Re-adjust the work rests and spark deflectors
to ensure that they are not more than 2mm from
the wheel.
10) Rotate the wheel by hand to check for free
movement and proper adjustments.
4. Using the wheel dressing set (See Fig 11,
12)
The supplied wheel dressing set is used for
smoothing the wheel surface when the wheel
used for long time as shown in Fig 11.
Place it back on top of the machine.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Grinder adjustments
During the life of the grinder some adjustments are
required to maintain a safe working environment.
Please ensure the following:
• Always adjust the eye shields to the most
comfortable and most effective angle to suit the
task being performed.
• As the wheels wear, the spark deflectors must
be adjusted to ensure that the distance from its
bottom edge to the wheel surface is not more
than 2mm.
• As the wheels wear, the work rests must also
be adjusted to make sure that the distance is
not more that 2mm from its edge to the wheel
surface.
Fig 12
Fig 11