ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
8. Bevel crosscuting
This cutting operation is the same as
crosscutting except the blade is at bevel angle
other than 0°.
Warning:
Always work to the right side
of the blade during this type of cut. The
mitre gauge (3) must be in the right side
groove (2) because the bevel angle may
cause the blade guard to interfere with the cut
if used on the left side groove.
1) Adjust the blade (1) to the desired angle,
and tighten the blade bevel lock knob.
2) Tighten mitre lock handle at 90°.
3) Hold workpiece fi rmly against the face of
the mitre gauge (3) throughout the cutting
operation (See fi g. 21).
Note:
When tilting the blade to 45°, the mitre
gauge handle will hit the blade guard.
9. Compound mitre crosscutting
This sawing operation is combining a mitre
angle with a bevel angle.
Warning:
Always work to the right side
of the blade during this type of cut. The
mitre gauge (3) must be in the right side
groove because the bevel angle may cause
the blade guard to interfere with the cut if
used on the left side groove. When tilting the
workpiece to 45° and push it toward the blade,
the blade guard may hit the blade. To avoid
injury, stop the work at that time.
1) Set the mitre gauge (3) to the desired angle.
2) Place the mitre gauge (3) in the right side
groove (2) of the table.
3) Set the blade (1) bevel to the desired bevel
angle and tighten the blade bevel lock knob.
4) Hold workpiece fi rmly against the face of
the mitre gauge (3) throughout the cutting
operation (See fi g. 22).
Fig 21
Fig 22
1
3
2
3
2
