ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
Note:
This tool is accurately adjusted before
shipping from the factory. Check the following
accuracy and readjust them if necessary in order
to obtain the best results in operation.
8. Installing the push stick and blade
spanner storage
1) Attach the hook (1) into the hole (2) of the side
table for push stick and blade spanner storage
spanner
spanner
(See fi g. 8).
9. Using auxiliary fence on the rip fence
A auxiliary fence should be used when ripping
material such as thin paneling to prevent the
material from catching between the bottom of
the fence and the table. When performimg some
special cutting operations, you can add a auxiliary
fence (3) to the either side of the rip fence (4).
1) Attach the square nuts to the rip fence with the
clamp handles (1) through the washers (5) and
holes in the rip fence.
2) Slide the auxiliary fence (3) to the square nuts (2).
3) Tighten the clamp handles (See fi g. 9).
10. Using auxiliary fence on the mitre
gauge
When performimg some special cutting
operations, you can add a auxiliary fence (2) to
the mitre gauge (1).
1) Attach the square nuts to the mitre gauge with
the washers (3) and screws (4).
2) Slide the auxiliary fence (2) to the square nuts (5).
3) Tighten the screws (See fi g. 10).
11. Installing the rip fence and mitre
gauge
1) Lift upward on the rip fence handle (1) so the
rear holding clamp (2) is fully extended.
2) Place the rip fence on the saw table, lowering
the front of the fence onto the table fi rst.
3) Push down on the fence handle (1) to lock
4) Place the mitre gauge (3) in the groove (4) on
the table top. (See fi g. 11).
Fig 8
Fig 9
1
2
Fig 10
Fig 11
1
2
3
4
5
2
5
3
1
2
33
4
