25
24
PLUNGE CUTTING (K)
WARNING!
Plunge cutting may be used only on soft materials such as
wood, gypsum plaster boards, etc.! Use only short saw blades!
Place the front edge of the base plate on the workpiece and switch the product on, wait
until it runs at full speed.
Press the product firmly against the workpiece and plunge the saw blade slowly into the
workpiece.
Continue to saw along the cutting line as soon as the complete surface of the base plate
rests on the workpiece.
POCKET CUTTING (L)
NOTE:
Choose between plunge cutting and boring a starting hole to start
a cut in the centre of the workpiece when there is no lead-in cut from the
edge.
Use a suitable drill to drill a hole of at least 12 mm on the cutting line.
Insert the saw blade that is fitted to the product into the hole and ensure it does not touch
the workpiece.
Switch the product on and wait until it runs at full speed before pushing the product
forward along the intended cutting line.
BEVEL CUTTING (M)
Adjust the required cutting angle; ensure the base adjustment lever (12) is properly
tightened.
Switch the product on and wait until it runs at full speed before placing it on the
workpiece.
Place the base plate flat on the workpiece and push the product forward at an even
speed.
OVERLOAD, TEMPERATURE AND CHARGING PROBLEM
Problem
Tool/ Battery Status Possible cause
Solution
Overload
protection
Product suddenly
Stops; The LED
work light (if fitted) is
flashing
Extremely high torque,
binding and stalling
situations, overloading
of the tool
Relieve the load
immediately, reset the
tool by switching off and
back on again.
Temperature
extremely high
The first and the
third LED light of the
POWER BAR will be
flashing alternately
Battery temperature
exceeds 77°C during
operation
Cool down the battery
to below 77°C for
operation and below
57°C for charging.
Low charge
Power for the tool will
drop quickly; The first
LED on the POWER
BAR begins to flash
The battery pack is
under 5% charge
Remove the battery
pack from the tool and
charge it
Other
problems
Short charges
Not fully charged
Make sure that the
battery is fully charged
every time by allowing
the charger to complete
its full charging cycle
Poor storage condition Always remove battery
from the tool and
charger when not
in use and store in
a dry secure place.
Avoid charging or
storing your battery in
temperatures below
5°C and above 40°C.
Cool down a hot battery
pack from a tool that
has just been operated
for approximately 30
minutes before storage