WARNING!
Hold the trigger guard (16) to avoid the hurt by its bouncing.
4. Take off filter (12a) carefully for further cleaning (Step 4).
5. Remove the seal (14c) from the union part (14b) if necessary.
6. Clean all the paint passages with a slightly damp cloth and a little soap after each
use. Use a cleaning brush (30) for hard to reach places.
7. Carefully clean all the disassembled parts with cleaning agent. Use the cleaning
needle (29) to remove any paint residue from the spray nozzle (14f). Be very
careful not to damage the spray nozzle hole.
8. Let all the parts completely dry and reassemble the spray gun (14).
9. If the spray gun (14) will be stored for a longer time, add lubricant (type: xxxxx) to
the spray nozzle (14f).
NOTE:
Follow below steps to reassemble the spray tip (14d) and spray
tip guard (14e).
– Combine the union part (14b) and seal (14c) together, and insert them
to the retaining nut (14a). Make sure that the seal (14c) is flush to the
inner surface of retaining nut (14a) (Fig. T, step 1).
– Insert the spray tip (14d) properly and make sure that the orientation is
correct (Fig. T, step 2).
– Hold the spray tip (14d) and the tip guard (14e) firmly and use the
spanner (27#) (25) to tighten the retaining nut (14) (Fig. T, step 3).
10.
Attention
:
– Never use aggressive solvents for cleaning.
– Never use hard materials like wire, wood, screwdriver etc. or abrasive agents for
cleaning.
– Never submerge the product in cleaning agent.
06
Cleaning for long term storage (Fig. U)
WARNING!
When cleaning for long term storage (more than 48 hours). It
is very important that the airless paint sprayer is not stored with any water
or water-based material left in the Pump, Hose, Tubes, or Spray Gun.
This will corrode the Product.
MNL_Erbauer_GB_EAPS600_600W Airless Paint Sprayer_V1_201029.indd 40
10/29/20 3:31 PM
41
