02
Pressure control knob (Fig. F)
1. Turn the pressure control knob (22) in a clockwise direction to increase the
pressure and in an anticlockwise direction to decrease the pressure. Different
thickness of materials will require different pressures to achieve a good result.
2. On a scrap piece of material, spray a test patch assessing the speed of stroke
for the required pressure setting. Lower pressure will require slower speeds, and
higher pressure faster speeds. If a satisfactory result is not achieved, dilution
of material may need to be carried out and also the pressure may need to be
adjusted.
03
Prime/Spray lever (Fig. G)
WARNING!
Always set the Prime/Spray lever (3) downward to the “Prime” mode
during adjustment, cleaning and maintenance. This will de-pressurise the
hose and make the tool safe to handle.
1. Rotate down the Prime/Spray lever (3) downward to “Prime” mode;
2. Rotate up the Prime/Spray lever (3) to “Spray” mode.
04
Spray angle adjustment (Figs. H, I)
Adjust the position of the spray tip guard (14e) to set up the orientation of the spray
pattern.
1. Loosen the retaining nut (14a) slightly in anti-clockwise using the spanner (27#)
(Fig. H, step 1).
2. Turn the spray tip guard (14e) in clockwise or anticlockwise (Fig. H, step 2) to the
desired position according to the intended operation.
Selecting the Spray Setting (Fig. I):
• Horizontal wide jet
• Vertical wide jet
3. Hold the spray tip guard (14e) in position and tighten the retaining nut (14a) in
clockwise to secure it afterwards (Fig. H, step 3).
05
Spray tip (Fig. J)
1. Rotate the spray tip (14d) in anti-clockwise direction with the arrow forward for
spraying use.
2. Rotate the spray tip (14d) in clockwise direction until the arrow backward for
cleaning use.
MNL_Erbauer_GB_EAPS600_600W Airless Paint Sprayer_V1_201029.indd 31
10/29/20 3:31 PM
32
