Erbauer 3663602796794, Original Instructions Manual

Page: 19 / 28

03
Dust extraction (Fig. F, G, H, I, J )
The product can be used with the dust collection box (10) or an external dust extraction
device.
Dust collection box
1. Attach the dust collection box (10) to the dust extraction outlet (6). Fig. F.
2. To remove the dust collection box (10), press both release levers (10b) and pull
the box off. Fig. G.
3. To empty the dust collection box, open the window of dust collection box (10c) by
pressing the release button (10a). Fig. H.
External dust extraction device
1. Attach a proper dust extraction device, e.g. a suitable vacuum cleaner attachment
(Ø35mm) to the dust extraction adaptor (9) and then attach to dust extraction
outlet (6). Fig. I.
2. To remove the dust extraction adaptor, press both release levers (9a) and pull the
dust extraction adaptor off. Fig. J.
Sanding paper without holes, e.g. from rolls or by the meter, should be
cut to suitable size and punctured with hole pattern by using the punch
(11).
Paper size:
• 115x230 mm for sanding paper with hook-and-loop system.
• 115x280 mm for sanding paper without hook-and-loop system.
Changing/attaching sanding paper with hook-and-loop system (Fig. A)
1. With the hook-and-loop system, sanding paper is simply removed by pulling off.
2. Align the hole pattern of the new sanding paper (12) with the one in the base plate
(7) to ensure efficient dust extraction.
3. With the hook-and-loop system, sanding paper is simply pressed on the base
plate.
Changing/Attaching sanding paper without hook-and-loop system (Fig. B, C, D)
1. Lift up and unlatch the two clamping levers (8) from both sides of base plate (7).
The front and rear clamping bars (8a) are now opened and loose. Pull out old
sanding paper and clean the base plate if applicable. Fig. B.
2. Align the hole pattern of the sanding paper (12) with the one in the base plate (7)
to ensure efficient dust extraction. Fig. C.
3. Guide the sanding paper (12) under the opened rear clamping bar (8a) to the stop
and clamp the sanding paper by latching the rear clamping lever (8) into the base
plate (7). Fig. D.
4. Fold the sanding paper (12) firmly around the sanding plate (7). Guide the other
end of the sanding paper (12) under the front clamping bar (8a) and clamp the
sanding paper by latching the front clamping lever (8) into the base plate (7). Fig.
D.
Punching (Fig. E)
Punch sanding papers without a hole pattern with the provided hole punch (11) after
attaching it to the base plate as instructed above.
1. Align the base plate (7) with a fitted sanding paper to the hole punch (11). Ensure
that the edges of the base plate are flush with the rim of the punch.
2. Press the product into the hole punch (11) fully.
3. Detach the hole punch (11) from the sanding paper.
19 18