Equipter RB4000, Service Manual

Page: 10 / 16

Axle Engagement System
NOTE: The fitting in the drive system should
be lubricated every 40 hours to ensure
proper operation. To access the grease
fitting:
1. Engage the parking brake.
2. Lower the stabilizers.
3. Release the safety latch and raise the front
steering wheels completely.
4. Tilt the dump box to gain access to the top
of the drive axle. Place prop under the dump
box for additional safety while lubricating the
axle engagement system.
5. Insert grease into the zerk.
NOTE: If the grease fitting is rotated away and cannot be accessed, the drive system can be
operated to spin the drive shaft. Use the drive control lever to “bump” the system until the grease
fitting is accessible.
For additional replacement parts or service assistance, contact the maufacturer’s recommended service
provider.
Front Axle Hub
1. Use a flat screwdriver to remove the
rubber grease cap.
2. Insert grease into the zerk until the zerk
is full.
3. Spin the tire to ensure the wheel turns
freely.
4. Replace the rubber grease cap.
5. Repeat on the opposite front wheel.
6
Grease Zerk
Wheel Lock Handle
1. Disengage the wheel lock pin.
2. Grease the wheel lock pin.
3. Replace the wheel lock pin.
Wheel Lock Pin