Equipment Technologies APACHE AS1010, Owner'S Manual, Page: 89 / 124

LUBRICATION AND MAINTENANCE
5-23
Replace Steering Pressure Filter
Check the indicator on top of the filter head. If
it is red, change the filter immediately; If the
indicator is green, change the filter at the next
500 hours or yearly maintenance interval.
To change the steering pressure filter, loosen
the filter bowl and remove the bowl and ele-
ment. Install a new filter element on the filter
head. Inspect the o-ring on the filter bowl and
replace if damaged. Install the filter bowl and
tighten to 45 ft-lb [61 N•m].
Replace Engine Oil and Filter
Operate the engine for approximately five
minutes to warm the engine oil. Shut off the
engine.
The engine oil drain plug is located on the
right side of the oil pan. Remove the engine
oil drain plug and drain the oil into a suitable
container. Properly dispose of the used
engine oil.
Install the drain plug and tighten to the torque
value below:
1. Plug with Copper Washer:
52 lb-ft [71 N•m]
2. Plug with O-ring:
37 lb-ft [50 N•m]
The engine oil filter is located on the right
side of the engine.
Turn the engine oil filter counter-clockwise to remove.
Dispose of the filter properly.
IMPORTANT: Do not overtighten the filter. Damage to
the seal can result.
Lubricate the seal on the engine oil filter, Part Number
201450241, and install. Tighten the filter, by hand, 3/4 to
1-1/4 turns after the seal contacts the filter housing.