-
6
-
Initial Power-up
Make sure all computers and KVM Switch are
powered down during installation. After connection,
you just power up the computers; the KVM Switch
will get enough power to operate from the computers.
This procedure ensures the KVM Switch receive
computer settings correctly when computer boots.
Therefore, the KVM Switch generates correct responses
and allows both computers to boot successfully without
user intervention. Should you decide to expand the
system in the future or to replace failed devices, you may
hot plug any additional power-downed computer and
KVM Switch to the system .
-
7
-
-----------------
Operations
Front Panel operation
You may switch to a different computer by pressing the
front panel push-button directly or by issuing hot-key
commands. The front-panel red indicator changes to
reflect the computer port selected. The indicator flashes
while in either Auto Scan or Manual Scan mode.
Hot-key commands
Hot-key command is a short keyboard sequence to
select a computer, to activate computer scan, etc. The
KVM Switch interprets keystrokes for hot-keys all the
time. A hot-key sequence starts with two left
Ctrl
keystrokes followed by one or two more keystrokes. A
built-in buzzer generates a high-pitch beep for correct
hot-key command; otherwise, one low-pitch beep for
error and the bad key sequence will not be forwarded to
the selected computer.
=
To select a computer:
left
Ctrl
+ left
Ctrl
+
1
Selects the computer at port 1.
left
Ctrl
+ left
Ctrl
+
2
Selects the computer at port 2
Do not use the keypad at the right of the
keyboard.
=
To start
Auto Scan
, automatically scan power-
