8 channel DMX chart
Channel
Value
Function
CH1
000-255
Full dimmer, 0-100%
CH2
000-008
No function
009-255
Strobe, slow to fast
CH3
000-255
The first head, Y position
CH4
(The first
head, LED
colour
selection)
000-008
No
function
129-136
R+G+B
009-016
R
137-144
R+G+W
017-024
G
145-152
R+G+A
025-032
B
153-160
R+B+W
033-040
W
161-168
R+B+A
041-048
A
169-176
R+W+A
049-056
R+G
177-184
G+B+W
057-064
R+B
185-192
G+B+A
065-072
R+W
193-200
G+W+A
073-080
R+A
201-208
B+W+A
081-088
G+B
209-216
R+G+B+W
089-096
G+W
217-224
R+G+W+A
097-104
G+A
225-232
R+G+B+A
105-112
B+W
233-240
R+B+W+A
113-120
B+A
241-248
G+B+W+A
121-128
W+A
249-255
R+B+A+W+A
CH5
000-255
The second head, Y position
CH6
000-008
No function
009-255
The second head, LED colour selection
CH7
000-255
The third head, Y position
CH8
000-008
No function
009-255
The third head, LED colour selection
4.4 DMX512 CONNECTION
1.
In the last unit, the DMX has to be terminated with a termination plug. Solder
a 120 ohm 1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin
XLR-plug and plug it in the DMX-output of the last unit.
2.
Connect the units together in a `daisy chain` with an XLR plug from the output
of the unit to the input of the next unit. The cable can not be branched or split
to a `Y` cable.
3.
The DMX output and input connectors are a pass-through type to maintain the
DMX circuit when one of the units’ power is disconnected.
4.
Each lighting unit needs to have an address setup to receive the data sent by
the controller. The address number is between 0-512
5.
The end of the DMX 512 system should be terminated to reduce signal errors.
6.
3 pin XLR cable wiring configuration
3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)
5.Troubleshooting
Following are a few common problems that may occur during operation
and some suggestions for easy troubleshooting:
A. The unit does not work, no light and the fan does not work
