Software version
Press the
MENU
button up to when the
is blinking on the display.
Pressing
ENTER
button and the display will show the version of software of
the unit. To go back to the functions press the
MENU
button.
Reset
Press the
MENU
button to select
. Press the
ENTER
button and all
channels of the unit will return to their standard position.
4. How To Control The Unit
1. Master/slave built-in preprogram function
2. Universal DMX controller
There is no need to turn the unit off when you change the DMX address as
new DMX address setting will take effect at once. Every time you turn the
unit on, it will show “
”on the display and move all the motors to
their ‘home’ position and you may hear some noises for about 20 seconds.
After that the unit will be ready to receive a DMX signal or run the built in
programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control
the other units to give an automatic, sound activated, synchronized light
show. This function is good when you want an instant show. You have to
set the first unit as master and select
show 1
,
show 2
,
show 3
or
show
4
from the
Show Mode
. The other unigts must be set to
either
Slave 1
(normal) or
Slave 2
(2 light show) mode. A DMX cable between the units
for daisy chaining is needed.
2-light show
In
slave mode
,
Slave 1
means the unit works normally and
Slave 2
means 2-light show. In order to create a great light show, you can set
Slave 2
on the second unit to get contrast movement to each other, even
if you have two units only.
4.2 DMX Controller
By using a universal DMX controller to control the units, you will need to
set a DMX address from 1 to 512 so that the units can receive a DMX
signal. Press the
MENU
button until
is showing on the display.
Press the
ENTER
button and the display will blink. Use the
DOWN
and
UP
buttons to change the DMX-512 address. Once the address has been
selected, press the
ENTER
button to confirm. To go back to the functions
without any changes press the
MENU
button again. Press and hold the
MENU
button one second or wait for one minute to go back to the main
menu.
Please refer to the below diagram to address your first 4 units
：
Channel
mode
Unit 1
Address
Unit 2
Address
Unit 3
Address
Unit 4
Address
1 channel
1
2
3
4
8 channel
1
9
17
25
10 channel
1
11
21
31
