JA07092020
U
-00169
6
Note (after all springs have been attached):
Correct material installation
– Corners of the screen material are properly wrapped around the corner edges of the
frame and material is evenly tensioned and flat, creating a nicely taut surface.
Incorrect material installation
–The corners of the screen material are not properly wrapped along the edge of the
frame leaving the material with unbalanced tension and an uneven finish. To correct, detach springs from material at
the corner(s) where material does not lie flat along the edge of the frame, reposition the material so that it lies flat
and wraps along the edge of the frame, and reattach springs to the material.
Edge Trim Installation
Step 10
: Place the edge trim frame pieces over each end of the frame.
Connect edge trim frames (
E/F
) together using the
Center Joints- M4(a)
and secure with four of the
M4x4 Screws(m)
as show in
Step 1
. Repeat for other side.
Once both top and bottom edge trim frames have been connected, attach the vertical (left/right) sides edge trim
frames (
D
) using the
Elbow Joints M4 (c)
and secure with four
M4x4 screws
(
m
) on all corners,
Step 2
.
Step 11
: Install the
angle cover
(
n.
) on each corner of the frame using the double-sided tape.
To avoid ripples forming in the material it is imperative that all of the corners are properly wrapped around the
edges as illustrated in the check mark diagrams.
c.
a.
m.
2.
1.
Tear off the double-sided tape.
m.
1.
2.
2.
Attention: The back of the material has labels indicating the TOP and BOTTOM. The top edge trim piece with
the logo should be installed at the top. The material is directional so it will not properly reflect if bottom side is
projected on.
n.
