-17-
TANK CLEANING
Unplug from the mains before cleaning.
By tank cleaning, proceed as follows:
1) Place the goods in special refrigerated containers, kept at the same temperature and remove the shelves
2) Unplug the unit
3) Leave the doors open and begin the operation of tank washing when the tank temperature is the
same as the ambient temperature.
4) Clean and dry the interior of the tank with a soft cloth, using neutral soap.
Then plug the unit and wait till the appliance reaches the right temperature before filling it again.
Warning!
Do not use water jets for cleaning: this can damage the electrical
parts.
Warning! Do not use mechanical appliances or other means to speed up the
defrosting process, other than those recommended by the manufacturer.
For a good preservation of the cabinet’s body
a periodical cleaning is necessary
.
EXTERNAL BODY
: When necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEEL SURFACES
: Wash with warm water and mild detergent, rinse well and dry
with soft cloth. Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL
: Wash with warm water and mild detergent, rinse well and
dry with soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES
: Only use products specifically designed for glass cleaning; It is not advisable
to use ordinary water which can leave a film of calcium on the surface of the glass.
INFORMATIONS ABOUT SERVICE
MALFUNCTIONS AND REMEDIES
Most of the functioning inconveniences are generally due to defective electrical connections.
These problems can usually be solved on the place.
The unit does not start
:
-check that there is voltage at the wall socket;
-check that the unit is properly plugged.
If the problem persists despite the above checks, contact your nearest service centre and empty
the unit.
The internal temperature is not cold enough
:
-check that the unit is not placed too close to any heating source;
-check the temperature setting;
-check that behind the cabinet air can properly circulate;
-check the perfect closing of the glass door.
If the prblem persist despite the above checks, contact your nearest service centre.
The unit is noisy
:
-check that all the bolts and nuts are properly fasten;
-check that the unit is placed on an even surface;
-check if any pipe or fan is in contact with any other part of the body.
