Chapter 2 Setup
49
2
Functions
Setting the paper width
• 80 mm (
initi
al se
tting
)
• 58 mm
Setting the print density
Selec
t
able from levels 1
t
o 13 (70%
∼
130%)
Setting the multi-tone print density
Selec
t
able from levels 1
t
o 13 (70%
∼
130%)
•
To directly configure the printer in the memory switch setting mode, see
"Memory Switch
Setting Mode" on page 88
.
•
For detailed information about the TM-T88V Utility, see the TM-T88V Utility User’s
Manual.
•
For detailed information about ESC/POS commands, see the ESC/POS Application
Programming Guide.
•
Be sure to install the roll paper guide when you select the 58 mm paper width. (See
"Changing the Paper Width" on page 37
.)
•
Once you change the paper width from 80 mm to 58 mm, you cannot change it back to
80 mm.
The print density can be set with DIP switches (2-3/2-4) or the customized value. (See
"Selecting the Print Density (DIP Switches 2-3/2-4)" on page 45
.) The initial setting of the
customized value is “Depends on the DIP switch settings.” If the customized value is
changed, the value set with the customized value is enabled.
•
First change the print density, and then configure the Multi-tone print density.
•
If you set the density too high, the contrast becomes lower. Select the density level
checking the overall tone balance of your image.
Summary of Contents for TM-T88V
