
100
Appendix
∗
1 The value is based on test results in accordance with JIS C60068-2-31:2013 (IEC 60068-2-31:2008).
∗
2 This is the result of an evaluation conducted by a third party evaluation organization based on JISC0920
(IEC60529:2001), and does not guarantee conformance to the standard, no damage, or no failure.
Storage environment
There is no abnormality in operation after the printer was stored under the following conditions, and
left at 25°C and 60% RH for two hours.
High temperature
Temperature: 70˚C {158˚F} Storage time: 120 hours
Low temperature
Temperature: -25˚C {-13˚F}
Storage time: 120 hours
Hot and humid
Temperature: 50˚C {122˚F}
Humidity: 90% RH
Storage time: 120 hours
Vibration resistance
When packed
Frequency: 5 to 55 Hz
Acceleration: Approx. 19.6 m/s
2
{2G}
Sweep: 10 minutes (half cycle)
Time: 1 hour
Orientation: x, y, and z
There is no external or internal visible damage and the unit operates
normally after being subjected to vibration.
Shock resistance
When packed
Packing: Epson standard package specifications
Height: 60 cm {23.62 in.}
Orientation: 1 corner, 3 edges, and 6 surfaces
There is no external or internal visible damage and the unit operates
normally after being dropped.
When unpacked
Height: 5 cm {1.97 in.}
Orientation: Lift one edge and release it (for all 4 edges)
There is no external or internal visible damage and the unit operates
normally after being dropped while not operating.
Drop impact resistance*1
210 cm {82.68 in.}
Acoustic noise
Operating
Approximately 53 dB (ANSI bystander position)
Note: The above noise value is based on our evaluation conditions.
Acoustic noise differs depending on the paper used, printing contents, and
the setting values, such as print speed or print density.
Water and dust
resistance
*2
Vertical placement
IP54 compliant
Note: Roll paper side is excluded. When roll paper recess is installed on the
bottom side.
Horizontal placement
IP54 compliant
Note: Roll paper side is excluded. When the belt clip is installed on the
bottom side.
Altitude
3,000 m or less
If the paper is left loaded for an extended period of time, the paper may become deformed and the
printing may become lighter in some areas. Therefore, when printing after leaving the paper
loaded for a long time, feed the paper about 30 mm before printing.