Epson TM-H6000II, Technical Reference Manual

Page: 78 / 122

3-24
Setup Rev. A
3.4.4.5 When Using Original Paper
When you use original paper such as P350 (F380), we recommend setting the DIP switches as
shown in the table below. The setting differs depending on each paper specification. See the
Other Qualified Suppliers for Thermal Paper section later in this chapter.
Note:
See the thermal paper section in Chapter 4 for information about thermal paper.
3.4.5 Memory Switches
This printer has “Memory switches“ which are software switches. A memory switch setting
utility can change the memory switch 1 or 8 to ON or OFF as shown in the table below (default:
all OFF):
• Switch 1
• Switch 8
Note:
Settings of the memory switch are stored in the NV memory; therefore, even if the printer is turned off, the
settings are maintained. Excessive use of this function may destroy the NV memory. As a guideline, do
not use this function more than 10 times a day.
For information about the Memory switch utility, please contact your dealer or EPSON.
When you use OPOS or APD, generally you don’t need to adjust memory switch because OPOS or APD
are able to set these items automatically.
Original paper type
DIP SW2
Print density
level
3 4
P350 (F380) ON ON 1
PD160R, AF50KS-E, P310, P300 OFF OFF 2
Bit ON OFF
1 Transmits the power ON notice Does not transmit the power ON notice
2
~
8 Reserved (Do not change the setting)
Bit ON OFF
1-2 Reserved (Do not change the setting)
3 Uses a 58 mm width roll paper Uses an 80 mm width roll paper
4 Uses two-color roll paper Uses monochrome roll paper
5-6 Reserved (Do not change the setting)
7 Slip paper jam detection: Disabled Slip paper jam detection: Enabled
8 Becomes recoverable error if the unit cover is open
during printing Goes offline if the unit cover is open
during printing